Laserpoint 3 on-machine calibration
-
Load a blank piece of paper into the cutter and have the pen tool loaded into the carriage arm.
-
Turn the machine on while holding down the right arrow key on the cutter.
-
Release your finger from the right arrow key once the screen on the cutter says "Welcome..."
-
The screen should say "move to blank". Use the arrow keys on the cutter to move the pen to the center of the piece of paper and press the origin button.
-
Press the enter key on the cutter. The cutter should draw and scan an "L" shape.
-
The screen of the cutter will display "success" if the calibration happens properly.
-
Press the enter button. You have now successfully performed an on-machine calibration of your Laserpoint 3!
Comments
2 comments
I just bought the LaserPoint3 and somehow can't get the cutter to calibrate. I followed your exact instructions but the pen is not drawing the L shape. The 3 rollers are locked down the paper but it is not moving the paper. What am I doing wrong?
I keep getting verify failure
Please sign in to leave a comment.