Skip to main content

Submit a request
Sign in

Sign in
Submit a request

USCutter
Vinyl Cutters
MH MK2 Series

Articles in this section

MH Vinyl Cutter User Manual - Getting Started
MH Series Setup and Instructional Video
USCutter Vinyl Cutter Warranties
MH Vinyl Cutter - Cutter is not being detected
My carriage arm is not moving up and down.
MH Vinyl Cutter - Carriage will not stop moving to the right/hits the right wall
Replacing the MH MK2 Motherboard
Will the MH- series allow me make rhinestone templates?
MH (Refine) Series plotter, what’s the Mechanical Resolution?
MH Power Supply

See more

My carriage arm is not moving up and down.

Greg H.

March 04, 2021 16:52
Updated

Was this article helpful?

0 out of 1 found this helpful

Have more questions? Submit a request

Related articles

MH Vinyl Cutter - Carriage will not stop moving to the right/hits the right wall
MH Vinyl Cutter - Cutter is not being detected
Replacing the Carriage on your MH MK2 series cutter.
MH Vinyl Cutter User Manual - Getting Started
Replacing the MH MK2 Motherboard

Comments

0 comments

Please sign in to leave a comment.

USCutter

Powered by Zendesk